PC-Rot Terminator® Wood Hardener

When it comes to restoring or repairing severely rotted and insect damaged wood, your product of choice is PC-Rot Terminator®.  PC-Rot Terminator® is structural wood hardener designed to strengthen decayed or rotted wood. The mixture is a low viscosity liquid that penetrates porous surfaces filling and sealing voids with an epoxy that cures to a hard but durable component. PC-Rot Terminator® is useful for replacement of missing wood fibers or wood resin. PC-Rot Terminator® fills the voids in the wood with an elastomer that has strength greater than wood. PC-Rot Terminator® acts as a binder that glues the wood fibers together. The wood fibers become much stronger in combination with the epoxy elastomer.

• Solvent Free: PC-Rot Terminator® contains 100% active ingredients and does not contain solvents which may evaporate and cause shrinkage.


• Wood Hardening: Worn and weathered wood can be rejuvenated with PC-Rot Terminator®. The surface can be made harder and less crumbly. A desk surface or hardwood floors can be made harder and wear resistant if the wood is ready to accept the epoxy consolidate. Seal the wood from the effect of wear and weather.


• Adhesive: PC-Rot Terminator® can be used as an adhesive on non porous surfaces. The mixture becomes thicker after 90 minutes of working time allowing for higher build and increased glue lines.


• Penetration: PC-Rot Terminator® will readily follow the grain of rotted wood. Removal of paint and varnish will increase the acceptance of the consolidant. For maximum penetration poke or drill holes into the wood or expose the grain of the wood by cutting into the wood. For vertical surfaces drill holes on an angle to hold PC-Rot Terminator®.  Reapply the PC-Rot Terminator® prior to cure if needed.

No posts found
 

Add new post